I 3d printed the forsaken spectre

Posted by Steve

Tuesday, October 5, 2021 7:29 PM

​

I bought a 3d printer just to make Valorant props and this is the first big print I have done. It took about 2 weeks to do from start to finish. I am currently making the dot exe vandal with glow in the dark paint, then the prime phantom.

References

  • https://www.reddit.com/r/VALORANT/comments/q17h6m/i_3d_printed_the_forsaken_spectre/
  • https://reddit.com/q17h6m

More Like This

Sinatra's godly clutch to keep Sens in First Strike

Myth - Sinatra god play

Posted by Otto
Sunday, December 6, 2020 11:19 PM

View Post

Is the phantom or vandal hard to use for anyone else?

Everyone from people I meet in ranked/personal friends to pro players all seem to have their own favorite when it comes to the vandal and phantom. Both have their own pros and cons, but for most people, they use the same choice 90% of the t...

Posted by Otto
Monday, November 9, 2020 6:02 AM

View Post

I wanted to find new Omen smokes on Fracture and it seems like ground renders too high in phased world in dish area

The geometry is also a bit off, especially near the ramp. I have no idea if it was the case before the patch, because I didn't smoke the dish area that often before. There are also some other places like this on Fracture, although much less...

Posted by Otto
Friday, October 7, 2022 7:00 AM

View Post